Maintenance - Central Machinery 91130 Owner's Manual

Maintenance and Servicing
procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the power cord
before performing any procedure in this section.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
cleaning, Maintenance, and Lubrication
1. BEFORE EAcH USE, inspect the general
condition of the tool. Check for:
• loose hardware
• misalignment or binding of moving parts
• cracked or broken parts
• damaged electrical wiring
• any other condition that may
affect its safe operation.
2. AFTER USE, wipe external surfaces
of the tool with clean cloth.
Page 16 For technical questions, please call 1-888-866-5797.
3. DAILy: Remove all sawdust and debris from the
Table Top and Dust Port Assembly with a soft
brush, cloth, or vacuum. Use premium quality,
lightweight machine oil to lubricate all moving parts.
4. Periodically, wear ANSI-approved
safety goggles and NIOSH-approved
breathing protection and blow dust out of
the motor vents using dry compressed air.
WARNING! If the supply cord of this
5.
power tool is damaged, it must be replaced
only by a qualified service technician.
Item 91130