Operation - Central Machinery 91130 Owner's Manual

Operating Instructions
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the power cord
before performing any procedure in this section.
TO pREVENT SERIOUS INJURy:
DO NOT OpERATE WITH ANy GUARD DISABLED, DAMAGED, OR REMOVED.
Moving guards must move freely and close instantly.
Installing and Removing collets
1. The Router includes a 1/4" Collet (90)
and a 1/2" Collet (84). The Collets may
need to be changed when using larger
or smaller router bits (not included).
2. Use the Wrench (87) to turn the Height
Adjustment Lock (89) counterclockwise
to loosen.
Figure L
3. Remove two M4 x 1 0 Screws (67) from Collet
Assembly Cover (81) and lift Cover from Height
Adjusting Ring (80). If necessary, clean off
any debris from previous cutting operations.
collet
Assembly
cover
Height
Adjusting
Ring
Page 12
Wrench
Height
Adjustment
Lock
Figure M
For technical questions, please call 1-888-866-5797.
4. Turn Collet Nut (85) counterclockwise
while pulling and holding the Spindle Lock
(108) forward. Remove Collet Nut.
collet Nut
5. Remove existing Collet from assembly. Install
the correct size Collet for router bit to be used.
6. Finger tighten the Collet Nut
back onto the assembly.
Figure O
Figure N
collet Nut
collet
Item 91130