Installing The Door And The Glass Panels; What To Do If - AEG BP7304001 User Manual

Hide thumbs Also See for BP7304001:
Table of Contents

Advertisement

2
B
Installing the door and the
glass panels
When the cleaning is completed, install
the glass panels and the oven door. Do

13. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
The appliance does not
heat up.
The appliance does not
heat up.
The appliance does not
heat up.
The appliance does not
heat up.
The appliance does not
heat up.
The lamp does not oper-
ate.
1
Problem
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
7.
Pull the door trim to the front to re-
move it.
8.
Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9.
Clean the glass panel with water
and soap. Dry the glass panel care-
fully.
the above steps in the opposite se-
quence. Install the smaller panel first,
then the larger.
Possible cause
The appliance is deacti-
vated.
The time of day is not
set.
The necessary settings
are not set.
The automatic switch-off
is activated.
The fuse is released.
The lamp is defective.
ENGLISH
Remedy
Activate the appliance.
Set the clock. Refer to
"Setting and changing
the time".
Make sure that the set-
tings are correct.
Refer to „Automatic
switch-off".
Make sure that the fuse
is the cause of the mal-
function. If the fuse re-
leases again and again,
contact a qualified elec-
trician.
Replace the lamp.
37

Advertisement

Table of Contents
loading

Table of Contents