Installing The Door And The Glass Panels; What To Do If - AEG EE3003011 User Manual

26 www.aeg.com
2
B
Installing the door and the
glass panels
When the cleaning is completed, install
the glass panels and the oven door. Do

11. WHAT TO DO IF...

WARNING!
Refer to the Safety chapters.
The cooking zones do
not operate.
The appliance does not
heat up.
The appliance does not
heat up.
The lamp does not oper-
ate.
1
Problem
5. Put the door with the outer side
down on a soft cloth on a stable sur-
face. This is to prevent scratches.
6.
Hold the door trim (B) on the top
edge of the door at the two sides
and push inwards to release the clip
seal.
7. Pull the door trim to the front to re-
move it.
8. Hold the door glass panels on their
top edge one by one and pull them
up out of the guide.
9. Clean the glass panel with water
and soap. Dry the glass panel care-
fully.
the above steps in the opposite se-
quence. Install the smaller panel first,
then the larger.
Possible cause
Refer to the operating instructions for the built-in
cooking surface.
The appliance is deacti-
vated.
The fuse is released.
The lamp is defective.
Remedy
Activate the appliance.
Make sure that the fuse
is the cause of the mal-
function. If the fuse re-
leases again and again,
contact a qualified elec-
trician.
Replace the lamp.