Installing The Chassis Brackets - Cisco ASR-920-10SZ-PD Installing Manual

Installing the Chassis Brackets

Installing the Chassis Brackets
The chassis is shipped with mounting brackets that can be installed on the front of the chassis. To install the
brackets on the front of the chassis, perform these steps:
SUMMARY STEPS
1. Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
2. Position one of the brackets against the chassis side, and align the screw holes.
3. Secure the bracket to the chassis with the M5 screws removed when performing Step 1. The recommended
maximum torque is 10 in.-lb.
4. Repeat Step 2 and Step 3 for the other bracket.
DETAILED STEPS
Step 1 Remove the rack-mount brackets from the accessory kit and position them beside the router chassis.
Figure below shows how to attach the brackets at the front position on the Cisco ASR-920-10SZ-PD Router for a 19-inch
EIA rack.
Figure 1: Attaching Mounting Brackets for a 19-inch EIA Rack
Step 2 Position one of the brackets against the chassis side, and align the screw holes.
Step 3 Secure the bracket to the chassis with the M5 screws removed when performing Step 1. The recommended maximum
torque is 10 in.-lb.
Step 4 Repeat Step 2 and Step 3 for the other bracket.
Cisco ASR 920-10SZ-PD Aggregation Services Router Hardware Installation Guide
2
Installing the Cisco ASR-920-10SZ-PD Router