Connecting To The 10/100/1000 Ports - Cisco ASR-920-10SZ-PD Installing Manual

Connecting to the 10/100/1000 Ports

If the module has a bale-clasp latch, pull the bale out and down to eject the module. If the bale-clasp latch is obstructed
and you cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow instrument to
open the bale-clasp latch.
Figure 10: Removing a Bale-Clasp Latch SFP Module
Step 4
Grasp the SFP module between your thumb and index finger, and carefully remove it from the module slot.
Step 5 For fiber-optic SFP modules, insert a dust plug into the optical ports of the SFP module to keep the optical interfaces
clean.
Step 6
Place the removed SFP module in an antistatic bag or other protective environment.
Connecting to the 10/100/1000 Ports
The router 10/100/1000 ports configure themselves to operate at the speed of attached devices. If the
Note
attached ports do not support autonegotiation, you can explicitly set the speed and duplex parameters.
Connecting devices that do not autonegotiate or that have their speed and duplex parameters manually set
can reduce performance or result in no linkage.
Cisco ASR 920-10SZ-PD Aggregation Services Router Hardware Installation Guide
16
Installing the Cisco ASR-920-10SZ-PD Router