Connecting A Usb Flash Device - Cisco ASR-920-10SZ-PD Installing Manual

Installing the Cisco ASR-920-10SZ-PD Router
For information about inspecting and cleaning fiber-optic connections see,
partner/tech/tk482/tk876/technologies_white_paper09186a0080254eba.shtml
We recommend that you wait for 30 seconds between the removal and insertion of an SFP on an interface
Caution
module. We recommend this to allow the transceiver software to initialize and synchronize with the Cisco
ASR-920-10SZ-PD Router. Changing an SFP more quickly could result in transceiver initialization issues
that disable the SFP.

Connecting a USB Flash Device

To connect a USB flash device to the Cisco ASR-920-10SZ-PD Router, remove the dust cap and insert the
memory stick in the USB port labeled USB MEM.
Note Retain the dust caps for later use.
The Flash memory module can be inserted only one way, and can be inserted or removed regardless of whether
the router is powered up or not.
Figure below shows the USB port connector on the Cisco ASR-920-10SZ-PD Router.
Figure 13: Cisco ASR-920-10SZ-PD Router Flash Token Memory Stick
Removing and Replacing a USB Flash Device
To remove and replace a USB flash token memory stick from and into a Cisco ASR-920-10SZ-PD Router,
follow these steps:
SUMMARY STEPS
1. Pull the memory stick from the USB port.
2. To replace the Cisco USB Flash memory stick, simply insert the module into the USB port labeled USB
MEM, as shown in Cisco ASR-920-10SZ-PD Router Flash Token Memory Stick figure. The Flash memory
module can be inserted only one way, and can be inserted or removed regardless of whether the router is
powered up or not.
Cisco ASR 920-10SZ-PD Aggregation Services Router Hardware Installation Guide
Connecting a USB Flash Device
http://www.cisco.com/en/US/
27