Handle Housing / Cover; Cover - Stihl BGA 85 User Manual

7.

Handle Housing / Cover

7.1 Removing the Handle
Housing
Removing
– Remove the right half of the
housing, b 6.2
– Lift the electronic module out of
its guides and disconnect the
wires, b 9.4
: Take the handle housing (1) out
of the left half of the housing.
Installing
3
1
4 2
: Fit the handle housing in the left
half of the housing:
Locate recess (1) on peg (2).
Locate adapter (3) on peg (4).
– Reassemble in the reverse
sequence.
BGA 85
7.2

Cover

Removing
– Remove the handle housing,
b 7.1
1
: Take out the screws (arrows).
– Hold the housing securely, e.g.
clamp it in a vise, use protective
jaws. Take care not to damage
the housing.
: Push the locking levers (arrows)
inwards and hold them in that
position.
1 2
: Pull the bottom end of the
cover (1) out of the retaining
ledge (2) on the handle housing.
: Continue pulling the cover away
from the handle housing until it
disengages from the other
retaining ledge (1).
– Inspect the cover and replace if
necessary.
1
13