Serial And Telnet Control; Rs-232 And Telnet Commands - Hall Research Technologies SC-1080R User Manual

Multi-Format Switcher & Scaler
1. Press the MENU button to display the OSD. Using the  arrows
buttons, move to highlight the 'FACTORY RESET' option under
'SETUP'
2. sub-menu and press the ENTER button.
parameters to the factory defaults. The output resolution will be set at
'1920x1080@60, which should result in a picture being displayed.
3. Press and hold the UP ARROW and DOWN ARROW  button on the
front panel simultaneously for 3 seconds. This causes all parameters to
revert to factory defaults.
4. Factory reset can be done via Web GUI, IR remote, RS232 or Telnet
command.

4.0 Serial and Telnet Control

The video input selection and signal parameter settings for the SC-1080R
can be controlled via an external control system by using the Telnet (Port
23) or RS-232 port on the unit.
Use a straight thru M/F DB9 serial cable to connect the unit to the PC. Only
the TX, RX and GND pins are implemented in the connector.
The RS-232 port operates at 19200 baud, no parity and 1 stop bit. In
response to a valid command, the SC-1080R will respond with the
commands with each line terminated by a CR and LF.

4.1 RS-232 and Telnet Commands

Command
S POWER 0
S POWER 1
R POWER
S SOURCE 1~8
R SOURCE
10
Response
S POWER 0
Power Off
S POWER 1
POWER 0~1
S SOURCE 1~8
SOURCE 1 ~8
The unit will reset all
Description
POWER OFF
POWER ON
SHOW POWER STATUS
SOURCE SELECT
1=HDMI 1 5=VGA 2
2=HDMI 2 6=VGA3
3=HDMI 3 7=YPbPr
4=VGA 1 8=CV
SHOW SOURCE STATUS