ABB REG670 Technical Manual page 105

1MRK502052-UEN B
Technical manual
Input value
500ms
Output value
IEC09000332 V2 EN
Figure 28: Sequence diagram for setting PULSED
Input function
All function keys work the same way: When the LHMI is configured so that a certain
function button is of type CONTROL, then the corresponding input on this function
block becomes active, and will light the yellow function button LED when high. This
functionality is active even if the function block operation setting is set to off. It has
been implemented this way for safety reasons; the idea is that the function key LEDs
should always reflect the actual status of any primary equipment monitored by these
LEDs.
Local Human-Machine-Interface LHMI
500ms 500ms
pulse time
Section 5
500ms
pulse time
pulse time
IEC09000332_2_en.vsd
99