Assembling The Differential Gear - Yamaha Rhino 450 YXR45FAV Service Manual

FRONT CONSTANT VELOCITY JOINTS, DIFFERENTIAL
GEAR AND FRONT DRIVE SHAFT
2. Install:
M
a. Apply molybdenum disulfide grease into the
b. Install the dust boots.
c. Install the dust boot bands.
NOTE:
• The new boot bands may differ from the orig-
• The dust boots should be fastened with the
L
3. Check:

ASSEMBLING THE DIFFERENTIAL GEAR

1. Measure:
2. Install:
M
a. Slide the shift fork sliding gear 1, which is
7 - 12
• dust boots 1
• boot bands 2, 3
New
MMM M MMM M M MMM M M MMM M
dust boots.
Molybdenum disulfide grease
70 g (2.5 oz) per dust boot (front
wheel side)
45 g (1.6 oz) per dust boot (dif-
ferential gear case side)
inal ones.
boot bands 3 at the grooves in the joint
shaft.
LLL L LLL L L LLL L L LLL L
• free play (thrust movement)
Excessive play → Replace the joint assem-
bly.
• gear lash
Refer to "MEASURING AND ADJUSTING
THE DIFFERENTIAL GEAR LASH".
• gear motor
MMM M MMM M M MMM M M MMM M
installed to the differential gear case cover,
to the right to put it into the 2WD mode.
DRIV
M MMM M M MMM M MMM
L LLL L L LLL L LLL
M MMM M M MMM M MMM