Table of Contents
Advertisement
Set Up the Stack
Pointer
Running the Sample
Program
Activating the Trace
Window
3-10 Examples
The 68000 emulator requires you to set up the system stack pointer
before you can run the program. To set up the system stack pointer,
you must first break into the monitor.
Processor, Break
To modify the system stack pointer, select:
Register, Modify
Use the Tab key to select register ssp, press Enter, type in the address
0BFEH, and press Enter once again.
To start the emulator executing the sample program, select:
Processor, Go, Address
Type in the module and symbol names associated with the sample
program's starting address, SRND.S:START. The status line will
show that the emulator is "Running user program".
When entering the name of a local symbol for the first time, you need
to include the module name. This causes that module to become the
default module, and the next time you refer to a symbol from that
module, you do not have to include the module name.
The examples which follow show results in the "zoomed" trace
window. To activate this window, select:
Window, Zoom
Then either type in, or use the Tab key to select "Analysis", and press
Enter.
Advertisement
Table of Contents
