Table of Contents
Advertisement
Specifying a
Simple Trigger
Suppose you want to look at the execution of the sample program after
the AGAIN address, but only after it has occurred three times (in other
words, after the program has executed its complete loop three times).
To do this, select:
Analysis, Trace, Modify
Modify the trace specification as shown in figure 3-4. (To access the
"patterns and expressions" screen, press the Enter key while the cursor
is in the "trigger on" field.)
Notice that the address symbol AGAIN is assigned to pattern "a" and
an occurrence count of "3" is specified.
To save the new specification, use the Enter key to exit out of the field
in the lower right corner.
Figure 3-4. Simple Trigger Specification
Examples 3-11
Advertisement
Table of Contents
