Transaction Processing Options - First Data 8006L2-3CR User Manual

7 Get to know your PIN Pad

Transaction processing options

The First Data PIN Pad has a chip card reader, a magnetic stripe reader and an integrated contactless reader
for processing transactions.
All chip cards must be inserted into the chip card reader as shown below.
>
Insert the credit card into the card reader with the gold contact pad facing upward, as shown below.
>
Leave the chip card in the reader until the transaction is completed and you are prompted to remove it.
>
The screen prompts will guide you through the transaction process.
If the card is capable of performing a contactless transaction, place the card over the contactless reader, as
shown below.
If the card does not have a chip or contactless capability, you can process transactions by swiping the
magnetic stripe through the PIN Pad.
Smart card reader — The integrated circuit card (ICC)
reader is located at the bottom end. Please make sure that
the gold ICC contact pad is facing upward when inserting
the card into the slot.
Magnetic card reader
right side of the PIN Pad. With the magnetic stripe facing
[inwards], slide the card in either direction through the slot
without stopping. If the card swipe fails, check the position
of the magnetic stripe and slide the card again.
Contactless card reader
antenna is embedded behind the display and PIN pad. The
reader's lights will show blue when the PIN Pad is powered
on to indicate the reader is working normally. To process a
contactless payment, place the contactless card near the
card reader antenna during a transaction.
— The card reader slot is on the
—The contactless card reader