Table of Contents
Advertisement
adjust the Low Limit (flashing).
Press the Arc Start/End Options button.
Use the the Mode Select Panel Control to
select another Parameter Name (flashing) and
repeat the above sequence until all Limits are
set.
4.
Press the selected Memory when all limits are set to
desired values. The MSP Display will read:
Use the Weld Mode or the Arc Start/End button
to either save or discard the changes
English
Maintenance
For any maintenance or repair operations it is
recommended to contact the nearest technical service
center or Lincoln Electric.
performed by unauthorized service centers or personnel
will null and void the manufacturers warranty.
Do not open this machine and do not introduce anything
into its openings. Power supply must be disconnected
from the machine before each maintenance and service.
After each repair, perform proper tests to ensure safety.
ROUTINE MAINTENANCE
Check weld cables, control cables and gas hoses for
cuts
PERIODIC MAINTENANCE
Not applicable.
CALIBRATION SPECIFICATION
All calibration is factory set on the MAXsa™ 10
Controller.
23
WARNING
Maintenance or repairs
WARNING
English
Advertisement
Table of Contents
