Lincoln Electric MAXsa 10 Operator's Manual page 16

Power-up Sequence
When power is first applied to the machine the MODE
SELECT Display reads "MAXsa Initializing...". Once the
PowerWave AC/DC has intialized (20 to 60 seconds) a
"lamp test" is performed.

All discrete LED's, seven segment displays and
alpha numeric displays will be turned ON turned ON
for 2 seconds

After 2 seconds all displays are turned OFF again
and the MODE SELECT Display will show:
After initialization is complete,the MSP Display will show
the weld mode, the upper displays will show the
parameters that were selected when the machine was
last powered down and the WELD MODE Indicator will
be ON.
English
Wire Feeder Setup
Use the INCH DOWN pushbutton to insert wire into the
feed mechanism.
Prior to inserting the wire make sure that the "Touch
Sense" option is disabled. (P.15 in the Setup Menu).
Setting Feed Forward/Reverse
While pressing either the FEED FORWARD or FEED
REVERSE pushbutton the MSP Display will read as
shown in Figure above and the preset wire feed speed
will be displayed on the left (AMPS/WFS) display.
The feed speed can be changed by adjusting the control
knob below the display while pressing either button.
FEED REVERSE Use to retract the wire from
the feed mechanism.
FEED FORWARD Feeds the wire downward
torward the work piece.
NOTE: The MAXsa™ 10 has an option in the Setup
Menu (P.15) to enable the "Touch Sense" circuitry. See
the Setup Menu. When P.15 is enabled and the FEED
FORWARD button is pressed, the display will read.
NEW PICTURE!!!!
This "Hot Feed" feature enables the output of the power
source and there is voltage on the wire while inching
down. Avoid touching any exposed parts as defined in
the SAFETY PRECAUTIONS.
Changing and Setting weld Modes
To select a weld mode, press the WELD MODE
SELECTOR button until the WELD MODE indicator
comes ON (it may already be lit by default at power up).
Turn the control; knob to select the desired mode. After
about 1 second, the parameters for the new mode will be
13
WARNING
WARNING
English