Advertisement
Quick Links
IM849
RETURN TO MAIN MENU
™
June, 2009
POWER FEED
10A CONTROLLER
Safety Depends on You
Lincoln arc welding and cutting
equipment is designed and built
with safety in mind. However, your
overall safety can be increased by
proper installation ... and thought-
ful operation on your part. DO
NOT INSTALL, OPERATE OR
REPAIR THIS EQUIPMENT
WITHOUT
READING
THIS
MANUAL AND THE SAFETY
PRECAUTIONS CONTAINED
THROUGHOUT.
nd, most
importantly, think before you act
and be careful.
IP 21S
OPERATOR'S MANUAL
Copyright © Lincoln Global Inc.
Advertisement
Related Manuals for Lincoln Electric POWER FEED IM849
Summary of Contents for Lincoln Electric POWER FEED IM849
- Page 1 IM849 RETURN TO MAIN MENU ™ June, 2009 POWER FEED 10A CONTROLLER Safety Depends on You Lincoln arc welding and cutting equipment is designed and built with safety in mind. However, your overall safety can be increased by proper installation ... and thought- ful operation on your part.
- Page 6 T T h h a a n n k k Y Y o o u u...
- Page 10 VAC IN NEUTRAL (31) VAC IN LINE (32) INSERT INSERT SCREW WIRE HERE DRIVER HERE REMOVE SCREW DRIVER FROM CAGE CLAMP HOLE. CAGE CLAMP...
- Page 12 SWITCH GROUP #1 SUPPLY START STOP INCH UP NOTE: TRAVEL AUTO and TRAVEL ON should not be closed at the same time. Either one OR the other should be closed at any time, and must remain closed to keep particular Travel Mode active. If neither switch is closed at any time, travel will be turned OFF, regardless of the welding state.
- Page 14 POWER FEED 10A CONTROLLER CONTROL BOX K2362-1 CONTROL CONTROL K1543-XX ARCLINK CONTROL CABLE POWER FEED 10SF WIRE DRIVE K2312-1 POWER WAVE AC/DC 1000 K2344-1 2 3 4 5 6 K1785-xx 14 — 14 PIN FEEDER CABLE ELECTRODE SENSE LEAD SUBARC CONTACT NOZZLE K231-xxx WORK...
- Page 15 CONNECT ALL SENSE LEADS AT THE END OF THE WELD DIRECTION OF TRAVEL CONNECT ALL WORK LEADS AT THE BEGINNING OF THE WELD...
- Page 16 the arc, or both,to keep fumes and gases from your breathing zone and general area.
- Page 18 14-PIN RECEPTACLE 4-PIN TRAVEL RECEPTACLE 3-PIN FLUX RECEPTACLE 5-PIN INPUT RECEPTACLE...
- Page 21 STEEL 1/8" IR PORT SETUP 60Hz SIN WAVE WELD MODE START OPTIONS AC CONTROL END OPTIONS...
- Page 22 Frequency Seconds Start Time...
- Page 23 P.11 Timers SETUP Seconds Crater Time Seconds SETUP Downslope Time...
- Page 25 English WFS Units Amps Arc Display Mode P.12 Travel Options P.12 Travel Starts P.12 SETUP Travel Ends P. 14 SETUP P.15 Touch Sense SETUP Start Button SETUP SETUP Reset Wire? Enabled...
- Page 26 Standard P.21 Shutdown Shutdown2 Select...
- Page 28 IR PORT WELD WFS WELD MODE ARC CONTROL IR PORT WELD WFS WELD MODE ARC CONTROL SETUP START OPTIONS END OPTIONS IR PORT WELD MODE AC CONTROL SETUP START OPTIONS END OPTIONS ENABLE LIMITS? SETUP START OPTIONS END OPTIONS...
- Page 31 Step 3. RECOMMENDED COURSE OF ACTION Step 1. LOCATE PROBLEM (SYMPTOM). Step 2. POSSIBLE CAUSE.
- Page 37 SHIELDED CABLE FLEX...
Need help?
Do you have a question about the POWER FEED IM849 and is the answer not in the manual?
Questions and answers