NEC EXPRESS5800/120Ed User Manual page 74

8. Orient the heat sink as shown in Figure 4-10 and install the thermal tape
square onto the heat sink in the exact position shown.
9. Position the heat sink above the processor so the thermal tape square
attached to the bottom of the heat sink is directly positioned above the
processor.
When performing the next three steps, be sure the heat sink
is held firmly in position. If the heat sink should slide across
the top of the processor, the thermal tape may be damaged.
10. Position the heat sink clip over the center of the heat sink and attach the
small end of the clip to the tab located on the base of the ZIF socket. See
Figure 4-11, A.
11. Insert a flat blade screwdriver into the tab of the retention clip.
12. Secure the clip onto the tab of the ZIF socket.
4-12 Upgrading Your System
Figure 4-10. Installing Thermal Tape
! CAUTION
Figure 4-11. Positioning the Heat Sink Clip
A