NEC EXPRESS5800/120Ed User Manual page 85

6. Slide the drive bay towards the top of the chassis until the tabs on the bay
are free from the chassis. Remove the drive bay from the chassis and place it
on an antistatic surface. See Figure 4-21.
Figure 4-21. Removing the Hard Disk Drive Cage
7. Slide the drive into the bay until the screw holes line up. It may be necessary
to temporarily loosen the mounting screws on the already installed drives to
position the new drive. Secure the drive to the bay with the four supplied
screws.
8. Replace the 3.5-inch drive bay. Insert the tabs into their slots on the chassis.
Slide the drive bay towards the bottom of the chassis until the tabs hit their
stops. See Figure 4-22 .
Figure 4-22. Installing the Hard Disk Drive Bay.
Upgrading Your System 4-23