NEC EXPRESS5800/120Ed User Manual page 77

Installing DIMMs
1. Power off the system and ensure it is disconnected from the AC power
source.
2. Remove the left side panel as described earlier in this chapter.
Observe static precautions. Use an antistatic wrist strap.
Hold DIMMs only by their edges.
3. If applicable, remove the dust cover from the DIMM socket in which you
are installing the DIMM.
4. Holding the DIMM module only by the edges, remove it from its antistatic
package.
5. Position the DIMM so that the two notches in the bottom edge of the DIMM
align with the keyed socket. See Figure 4-14.
6. Insert the bottom edge of the DIMM into the socket, and press down firmly
on the DIMM until it seats correctly.
7. Gently push the plastic ejector levers on the socket ends to the upright
position.
8. Repeat the steps to install each additional DIMM.
9. Replace the left side cover.
10. Plug in the server power cord, and power on the server.
! CAUTION
Figure 4-14. Inserting Memory DIMMs
4 3 2 1
Upgrading Your System 4-15