Initial Start Up - Automatic Mode; Robot Safety Stop; Automatic Return To The Charging Station - AMBROGIO LINE 250 User Manual

The automatic cycle is started during the initial start-up or after a period of inactivity.
EN
1. Check that the height of the lawn surface to mow is compatible with the proper functioning of the robot (see "Technical
Specifications").
2. Adjust the cutting height as desired (see "Adjustment of Cutting Height).
3. Check that the work area has been correctly marked and that there are no impediments to the regular functioning of the robot
as indicated in the section "Preparation and Marking the Boundaries of the Work Areas" and following sections.
4. Position the robot inside the charging station.
5. Press the "ON/OFF" button and wait a few seconds for the robot to turn on completely. Follow the instructions on the display
and enter the password if prompted.
6. If starting the robot for the first time, it is necessary to program the settings. However, if starting the robot after a long period
of inactivity, check that the programmed functions correspond to the actual condition of the lawn to be mowed (e.g. addition
of a pool, plants, etc.) (See "Programming Mode").
7. After a few seconds, the message "CHARGING" will appear on the display.
8. The robot starts to mow the lawn according to the modes programmed.
9. Check there are no large puddles after a heavy rain, otherwise the area must be put in order or make sure the robot is in
"Pause".
During use, it may be necessary to stop the robot. In normal conditions, the robot can be stopped with the "STOP" key. In case
of danger or when performing any maintenance, it is necessary to stop the robot in safe conditions in order to prevent the blade
from accidently starting. First press the "STOP" button and then the "ON/OFF " button. Disconnect the power plug from the
electrical outlet.
Important
The robot safety stop is necessary during
maintenance and repairs (for example, blade
replacement, cleaning operations, etc.).
To start, proceed as indicated:
-
position the robot inside the cutting area;
-
press the "ON/OFF" button to turn on the robot and run the
start-up procedure again.
If the robot is started up outside of the cutting area, the blade
motor will not start and after briefly searching for the signal, the
robot will show "OUT OF BORDER" on the display. Press "ON/
OFF", position the robot inside the cutting area and carry out the
start up procedure again.
The robot stops the work cycle if the following conditions are verified:
-
End of working time: at the end of the working time, the robot automatically returns to the charging station and starts
operating again according to what has been programmed (see "Programming Mode").
-
Rain: with the function active, the robot returns to the recharging station automatically and will start working again as
programmed (see "Programming mode").
- Battery to be charged: the robot automatically returns to the charging station.
-
Eco Mode: if the sensor detects that the lawn has already been mowed, it automatically returns to the charging station and
starts operating again according to what has been programmed (see "Programming Mode").
User's manual
INITIAL START UP – AUTOMATIC MODE

ROBOT SAFETY STOP

AUTOMATIC RETURN TO THE CHARGING STATION

28
STOP
ON/OFF