Start-Up - AMBROGIO 6060BA0 User Manual

RECHARGING ROBOT
A. HIGH BATTERY:
(GREEN LED STEADY ON)
full battery level.
1 (GREEN LED 1 FLASH)
medium battery level.
B. LOW BATTERY:
(RED LED STEADY ON)
low battery level.
C. ON/OFF:
(GREEN LED STEADY ON)
robot in operation.
1. Check that the grassy surface of the lawn to mow is at a
height which is compatible with the proper functioning of the
robot (see technical specifications).
2. Adjust the desired cutting height (see cutting height
adjustment).
3. Check that the work area is correctly delimited and that there
are no impediments to the correct functioning of the robot
as indicated in the section "Preparation and defining the
boundaries of the work areas" and following sections.
4. Position the robot near the charging zone.
5. Connect the black jack to the wheel with the black "-" symbol
and the red jack to the wheel with the red "+" symbol. Once
connected, the robot turns on automatically and displays the
battery charge level (see "meaning of led combination").
6. At the end of charging, disconnect the robot and press the "ON/OFF" button. On first use, always charge the batteries for at
least 4 hours.
7. Position the robot inside the grassy surface in an area where the grass is at least 1 metre (40.00 ") from any obstacle.
8. Press the "OFF/ON" key and wait a few seconds for the robot to turn on completely.
9. Press "PLAY/PAUSE" key to start the robot.
Once the robot has stopped due to the reasons described in the chapter "Robot Stop", activate the safety stop and reposition
the robot inside the power supply unit for recharging.
Important
For a better cutting performance and correct functioning of the recognition sensor, do not start the robot in
case of rain or in very humid conditions. The best results are obtained in the middle of the day.
(A)
(D)

START-UP

17
(C)
P LAY
PAU SE
STOP
OF F
(B)
ON
User's manual
EN