Visualising The Display During The Work Phase; Prolonged Inactivity And Restarting - AMBROGIO LINE 250 User Manual

Hide thumbs

Table Of Contents

Table of Contents

While in operation, the following data appears on the display of

the robot:

speed of mower;

cutting blade speed;

percentage of battery charge.

While the robot is charging, the display shows the charging level.

If the robot is outside the working time, the display shows the day

and time of the next scheduled start.

After a long period of inactivity of the robot and before the mowing season, it is necessary to perform a series of operations to

guarantee the correct functioning at the time of reuse.

1. Fully charge the battery before winter storage. Recharge the battery at least once every five months.

2. Have the routine maintenance performed by an authorised dealer. This is essential for keeping the robot in good condition.

The assistance service usually includes the following operations:

•

total cleaning of the robot, the cutting blade and all the other moving parts;

•

cleaning of the inside of the robot;

•

checking of robot functioning;

•

checking and, if necessary, replacement of any worn parts such as the cutting blade, the brushes (only in robots equipped

with brushed motors);

•

checking of the battery capacity;

•

if necessary, the dealer may also load new software.

3. Accurately clean the robot and charging station (see "Robot Cleaning")

4. Check any worn or damaged components such as the cutting blade and evaluate their replacement.

5. Store the robot in a protected and dry place with an ambient temperature between 10° and 20° C, out of reach of foreign

elements (children, animals, other foreign objects, etc.). Store the robot at a temperature below 20°C in order reduce the

automatic discharge of the batteries.

6. Disconnect the power plug (A) from the electrical outlet.

7. Cover the charging station (C) to prevent any foreign materials from getting inside (leaves, paper, etc.) and for preserving

the contact plates.

Restarting

Before restarting the robot after a long period of inactivity, proceed

as follows:

1. connect the plug of the power supply unit (A) to the electrical

outlet;

2. reconnect the main electrical power supply;

Restore the normal functioning of the robot as described in chapter

"INITIAL START UP – AUTOMATIC MODE.".

User's manual