AMBROGIO LINE 250 User Manual page 27

Garden set up
EN
10:30
Setting of work area
A1 A2
⏎
Work schedule
DIMENSION
100
DISTANCE WIRE DIRECTION
25
⏎ ⏎
secondary area 2
(20%, 30MT, Anti-clokwise)
anti-clockwise direction
User's manual
A3 A4
1 2 3
DISTANCE
100
4 5 6
7 8 9
ECO MODE
ON
0
primary area
secondary area 1
(30%, 60MT, clokwise)
clockwise direction
Sets the characteristics of the mowing zone.
In gardens with one area, at least one zone must still be set.
Up to 4 areas can be set.
Press the area that you want to configure.
To disable an area, set the size to 0 m
For each area of the garden you must set:
-
dimension. The indicative size of the work area in square metres;
-
distance. The distance required by the robot to reach the inside of the
area by following the perimeter wire. To ensure that the robot starts
working inside the desired area, it is recommended to use the middle of
the work area as a reference for the distance. Set the value to 0 for the
area where the charging station is positioned;
-
direction. Shortest direction to reach the work area. The direction can
be "clockwise" or "counter-clockwise". On exiting the charging station, the
robot will follow the wire in the set direction;
-
wire distance. The distance of the robot from the perimeter wire for
reaching the work area. Set this value to "0cm" in complex gardens with
many obstacles near the perimeter wire and/or gardens with narrow
passages;
-
ECO mode. If enabled and the robot detects that the lawn surface has
been mowed, the working time in this area is reduced and the robot will
move to the next step.
26
.
2