Installation Of Perimeter Wire - AMBROGIO LINE 250 User Manual

Hide thumbs

Table Of Contents

Table of Contents

The perimeter wire can be buried or laid on the ground. If you

have a wire layer machine, it is better to bury the wire for greater

protection.

Otherwise, install the wire on the ground with the pegs provided

as described below.

Important

Start laying the perimeter wire from the area where

the charging station is installed, leaving a couple of

extra meters so that it can be cut down to size when

connecting to the power unit during the final phase.

Ground wire

Cut the grass as low as possible with a grass trimmer or brushcutter

along the entire path where the cable will be laid. This will make it

easier to lay the cable in contact with the ground and reduce the

risk of the robot damaging the insulation.

1. Position the wire in a clockwise direction along the entire path and

secure it with the pegs supplied, making sure there is a maximum

distance of around 100 cm (39.37 inches) between each peg. The

wire must be in contact with the ground to prevent it from being

damaged by the robot before the grass covers it.

When laying the perimeter wire, follow the installation

direction around the flowerbeds, i.e. a counter-clockwise

direction.

In curved sections, secure the wire so that it is not twisted,

but curves nicely (radius of 20 cm).

wire fastening pegs

radius of 20 cm

Buried wire

1. Dig an even furrow in the ground (approximately 2-3 cm or 0.787-1.181").

2. Position the wire in a clockwise direction along the track at a depth of a couple of centimetres. Do not bury the wire deeper

than 5 cm, so as not to reduce the quality and intensity of the signal picked up by the robot.

3. During the laying of the wire, it may be necessary to secure it in some points with the pegs provided in order to hold it in place

when covering with the ground.

4. Cover all the wire with soil and make sure it remains taut in the ground.