Triton T300si Installation And Operating Instructions Manual page 28

Fig.
Fig.
T300si wireless remote electric shower
400mm
approx
250mm
approx

Cut the riser rail to length. If required, use the
guide bracket for additional support.
Slide the trim ring onto the bridging bracket. Fit
the upper riser rail into the top of the bridging
bracket, making sure the cut-out engages the
bracket lug.
Fit the ceiling trim onto the upper section of riser
rail. Offer the assembled riser rail and bracket
up to the ceiling. Secure the bridging bracket to
the wall using the screw supplied and slide the
ceiling trim into place (Fig.).
Assemble the 700mm riser rail into the bottom
bracket and fit to the bridging bracket. Using
a spirit level, align the riser rail and mark its
position. Drill and plug the bottom bracket screw
fixing.
Slide the trim ring onto the bottom bracket and
slide towards the base.
Fit the 700mm riser rail into the bottom bracket
and then locate the top of the rail into the
bridging bracket. Secure the bottom bracket to
the wall (Fig.).
See 'Fitting the control panel bracket' for details on
how to fit the remote control cable and control
panel to the control bracket.