Triton T300si Installation And Operating Instructions Manual page 18

Fig.
Fig.
Fig.
T300si wireless remote electric shower

Procedure
Unscrew the top and bottom retaining screws
(Fig.) and lift cover from the backplate. To
allow access to the pipe and cable connections,
remove the two screws (Fig.) and take off the
trimplate.
After choosing the site for the shower, use the
backplate as a template and mark two fixing
holes (Fig.). Drill and plug the wall. (The wall
plugs provided are suitable for most brick walls
— use an appropriate masonry drill, but if the wall
is plasterboard or a soft building block, you must
use suitable wall plugs and a suitable drill bit).
Screw top fixing screw into position leaving the
base of the screw head protruding 6mm out
from the wall.
Entry positions for the mains water are from the
bottom or from the rear.
Cable entry is via the top or rear.
note: Deviations from the designated entry
points will invalidate product approvals.
If a bottom surface entry is required for the
mains cold water then the necessary hole will
need to be cut out in the trimplate and cover
(Fig.).
If a surface cable entry from the top is required
then the relevant hole in the backplate will need
to be cut out (Fig.0).
Hook the backplate over the top screw and fit
the bottom fixing screw into position.
DO nOT fully tighten the screws at this stage,
as the fixing holes are elongated to allow for
out of square adjustment after the plumbing
connections have been completed.