Resetting The Unit; Manual Operation - ESI ESRTP4RF User And Installation Instructions Manual

Resetting the Unit

To reset the programmer, hold reset for approx. 3
seconds. The system and programme will restore to the
factory default settings. Hold the Next button and press
the reset button to restore to factory default settings.

Manual Operation

It is possible to operate the receiver manually. This may be
necessary where, for example, the batteries in the
Thermostat (Transmitter) are depleted and therefore the
heating cannot turn ON or OFF.
1. To engage the manual override, press the MANUAL
button on the receiver, which will then light up with a
green background. This shows that the manual override is
active.
2. Use the M/A button to manually override the status of
the receiver. If ON, the heating will turn OFF (M/A red light
goes off). If OFF, the heating will turn ON (M/A red light
comes on). N.B. It is important to remember that the
automatic control of the receiver is now off and the receiv-
er will only respond to manual operations.
3. To return to Auto mode, press the MANUAL button on
the receiver and the green light will turn off. The receiver
should now be back in Auto mode, recieving commands
from the thermostat.
N.B. If the receiver cannot receive a signal for 30 minutes,
both the red and green light will flash and the unit will
need to be reconfigured.
13