Setting The Operation Mode (5/2 Day, 7 Day Or 24Hr); Setting The Programme - ESI ESRTP4RF User And Installation Instructions Manual

Setting the Operation Mode (5/2 day, 7 day, 24hr)
1. Switch the slider to PROG.
2. Press +/– buttons to move between 7 day, 5/2 day or
24hr operation.
5/2 Day operation is shown by MO, TU, WE, TH, FR
flashing (5 Day) and then SA, SU flashing (2 Day)
7 Day operation is shown by just one day flashing at a
time
24 hr operation is shown by MO, TU, WE, TH, FR, SA, SU
flashing at the same time.
3. Wait 15 seconds to automatically confirm and return to
Run mode or press Next
Programme'

Setting the Programme

1. Choose between 5/2 day, 7 day or 24 hr operation (see
above steps 1-2).
2. Press the Next
be displayed (the 1st temperature event).
3. Press +/- to set the time (10 minutes increments). Press
the Next
4. Press +/- to set the temperature (increments of 0.5°c).
Press the Next
ture event (e.g P2).
5. Repeat steps 3 - 4 for all temperature events.
6. Press A to accept/confirm temperature events and move
to the next day/block of days.
7. Repeat steps 3-6 until all days have been set. Then wait
15 seconds to automatically confirm and return to run
mode or press the Home button.
button. The time will flash and P1 will
button and the temperature will flash.
button to go to the next time tempera-
to move to 'Setting the
8