Replacing The Thread Take-Up Lever - ELNA 9900 Service Manual

Replacing the Thread Take-up Lever

Setscrew
Thread take-up lever Moving head case
0.2 mm thick gauge
1. Remove the moving head
2. Remove the E-ring.
3. Loosen the setscrew on the thread take-up
4. Pull the thread take-up lever shaft out in the
5. Replace the thread take-up lever.
E-ring
6. Attach the E-ring.
7. Insert a 0.2 mm thick gauge between the
8. Attach the moving head.
28
23).
lever shaft.
direction of the arrow. Remove the thread take-
up lever to replace.
moving head case and thread take-up lever.
Tighten the setscrew while pressing the thread
take-up lever shaft in the direction of the arrow.
elna 9900
(see pages 22 and