Replacing The Dynamic Cutter Blade - ELNA 9900 Service Manual

Single head 4-needle embroidery machine
Hide thumbs Also See for 9900:
Table of Contents

Advertisement

Replacing the Dynamic Cutter Blade

Setscrew
Drive shaft ring
Drive shaft unit
Lever unit
Link shaft
Setscrews
Setscrews
1. Remove the 2 setscrews and needle plate.
2. Turn the power switch on while pressing the Start/
Stop button and Thread cutter button at the same time
to open the Factory Adjusting window.
Press the Phase key to open the Phase Sensor
adjusting window and press the All Init key.
Press the Cancel key to return to the previous
window.
Press the Cut Motor key to open the Cut Motor
adjusting window. Press Divide key to move the
dynamic cutter blade forward.
3. Loosen the 2 setscrews and remove the drive shaft
ring.
4. Remove the cutter drive shaft unit from the frame.
Remove the two setscrews and replace the dynamic
cutter blade.
5. Insert the drive shaft into the frame and link pin of the
cutter drive shaft unit into the hole in the lever unit.
6. Attach the drive shaft ring and tighten the 2 setscrews
while pressing the ring and shaft unit each other with
your fingers.
NOTE:
Be sure that there is no thrust play in the shaft unit.
7. Adjust the cutter blades position (see following pages
39 and 40) and test auto thread cutting.
8. Attach the needle plate.
37
elna 9900

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents