Adjusting The Thread Catcher Holder - ELNA 9900 Service Manual

Adjusting the Thread Catcher Holder

Setscrews (A)
L o w e r t h r e a d
catcher holder
Setscrews (B)
1. Remove the static head cover (right) (see page 5).
Rod shaft 2. Remove the thread catcher panel and lower thread
3. Loosen the 4 setscrews (A).
4. Pull the thread catcher out to set the tip of the thread
NOTE:
If an adjustment allowance of the thread catcher holder is
not enough, loosen the 3 setscrews (B) and move the
thread catcher unit.
5. Check if the thread catcher moves smoothly by
6. Press the thread cutter button to test thread cutting
Thread catcher
7. Attach the parts removed in steps 1 and 2.
31
guide plate (see pages 18 and 19).
catcher on the lower thread catcher holder.
Move the thread catcher holder up or down so the
lower surface of the thread catcher touches the upper
surface of the lower thread catcher holder.
moving the rod shaft with your hand.
Tighten the 4 setscrews (A).
and catching.
elna 9900