Replacing the Take-up Lever Cam Roller
Drive cover
Thread take-up lever spring
Setscrew
Thread take-up lever shaft Thread take-up
Thread take-up
lever shaft
Cam roller
shaft
Setscrews
Connector
lever unit
Washer
Cam roller
Setscrew
To remove:
1. Remove the spool stand, static head cover
(right), right cover, left cover and thread tension
panel.
2. Remove the 3 setscrews and drive cover.
3. Remove the thread take-up lever spring with
pliers.
4. Loosen the setscrew. Remove the thread take-
up lever shaft, thread take-up lever unit and
washer.
5. Loosen the setscrew. Remove the cam roller
shaft and cam roller.
To attach:
6. Reverse the procedure above.
When attaching the thread take-up lever shaft,
tighten the screw while pressing the thread
take-up lever shaft lightly.
14
elna 9900