Changing A Program - Simpson SWT8043 User Manual

INTERRUPTION OF A
5.8
PROGRAM
If you have started your wash and
you wish to stop it for some reason,
press the Start/Pause button to
enter PAUSE mode. The time
remaining is shown then " PAUSE ".
Press the Start/Pause again. The
program will continue.

CHANGING A PROGRAM

5.9
You can turn the Program Selector
Knob to a new program position at
any time. If you do move the
Program Selector Knob the effect
will be different depending on the
status of the machine at the time
you do this, as follows:
When the machine is in PAUSE
mode, moving the Knob to a
new position 3 short beeps to
remind you that cannot change
the program in pause mode.
When the machine is running,
moving the Knob to a new
position will result in the machine
continuing the wash and
3 beeps to remind you that this
option is not allowed.
CHANGING THE OPTIONS
5.10
It is possible to change only before
start the program.
AT THE END OF THE
5.11
PROGRAM
-
The appliance stops automati-
cally.
-
The display will show
-
SWT1023A : " FINISHED "
-
SWT1043 / SWT9043 / SWT8043
SWT9043A : " END "
and with End sound every
15 second in 2 minutes.
-
Turn the Program Selector knob
to the position " Off " or
Press the ON/OFF button
(SWT1023A)
-
Remove the laundry from the
appliance. Make sure that the
washing tub is empty.
- Keep the lid ajar, to prevent the
mildew and odours.
- Turn off the water tap.
AUTO OFF
5.12
After 5 min without any user
interaction with the appliance, during
the machine is in stand by or after the
end of the cycle, the appliance receives
no further instructions, it will
automatically turned Off
(for energy savings in conformity with the
standards on energy consumption).
All the settings are stored so that
when the appliance is turned back on,
the program is ready or if the auto-off
mode was triggered after the end of the
cycle, the user can see that the cycle
ended normally, and can restart it.
23