Simpson SWT8043 User Manual page 14

14
DISPLAY
3.6
The display shows the following information:
MACHINE IN PAUSE MODE
SWT1023A
User needs to touch [Start / Pause] button
once to pause the appliance.
Under the remaining time is show text <PAUSE>
The Start/Pause button LED will blink.
WASH CYCLE IN PROGRESS
SWT1023A
After selecting a program, the duration is
displayed in hours and minutes
(for example 2:34 which means 2 hour
and 34 minutes)
The duration is calculated automatically on the
basis of the maximum recommended load
for each type of fabric.
After the program has started, the time
remaining is updated every minute.
The Start/Pause button LED will always light
(not blink) to indicate that now machine is in
executing mode.
END OF PROGRAM
SWT1023A
When the wash program is completed,
the display shows text <FINISHED> or
<END> .
The Start/Pause button LED will
turn Off.
SWT9043A / SWT1043
SWT9043 / SWT8043
SWT9043A / SWT1043
SWT9043 / SWT8043
SWT9043A / SWT1043
SWT9043 / SWT8043
LID LOCK FEATURE
Start/Pause LED
This is a safety feature so as to prevent
anyone from opening the door lid when
the drum is spinning.
To unlock the lid, user needs to tap
[Start / Pause] button once to pause the
appliance and the display will turn Off the lid
lock icon.
The mechanical lock unlocks when the
drum stops spinning.
The Lid Lock indicator
the feature activate
ENABLING/DISABLING END OF
WASH BEEP
User can also disable the buzzer by pressing
the [Water Level] button + [Spin] button
down for 3 sec and release.
it will disable power on sound also.
The volume level is set in the factory and
cannot be adjusted by the user.
3.7
TO START THE WASH CYCLE /
PROGRAM
Press the Start/Pause button to Pause.
Start/Pause to Pause is used to Start,
Stop and Continue the wash.
If you have started your wash and you
wish to stop it for some reason, press the
Start/PauseTo Pause touchpad and
Start/Pause LED
hold it for 1.2 secounds to enter
pause mode.
(Except SWT8043)
START/PAUSE BUTTON
will light up when