Changing A Program - Simpson SWT5541 User Manual

18
5.8 INTERRUPTION OF A
PROGRAM
If you have started your wash and
you wish to stop it for some reason,
press the Start/Pause button to
enter PAUSE mode. The time
remaining is shown then "
Press the Start/Pause again. The
program will continue.
5.9

CHANGING A PROGRAM

You can turn the Program Selector
Knob to a new program position at
any time. If you do move the
Program Selector Knob the effect
will be different depending on the
status of the machine at the time
you do this, as follows:
When the machine is in PAUSE
mode, moving the Knob to a
new position will result in the
machine resetting to the start of
the new program.
When the machine is running,
moving the Knob to a new
position will result in the machine
continuing the wash and the
display will show "
flashing with 3 consecutive short
beeps to remind you that this
option is not allowed.
5.10
".
5.11
" and
CHANGING THE OPTIONS
It is possible to change only some
option after the program has
started.
1. Press the Start/Pause button to
enter PAUSE mode.
2. Change the options.
3. Press Start/Pause button again.
The program will continue.
AT THE END OF THE
PROGRAM
-
The appliance stops automati-
cally.
-
The display will show "
and flashing with 3 consecutive
long beeps .
-
Turn the Program Selector knob
to the position "Off".
-
Remove the laundry from the
appliance. Make sure that the
washing tub is empty.
- Keep the lid ajar, to prevent the
mildew and odours.
- Turn off the water tap.
"