Installation Notes - ZENEC Z-N326 User Manual

INSTALLATION NOTES

CAUTION
● The installation of the ZENEC system should be carried out by an authorized installer. Specific
knowledge and tools are required to do the installation. Incorrect installation can cause damage
to the vehicle and the ZENEC system.
● Correct functioning can only be guaranteed when you use the ZENEC original accessories
included in the kit or those optionally available. The ZENEC system and the original accessories
must under no circumstances be modified or altered in any way. Inappropriate actions can
cause damage to the vehicle and the ZENEC system.
NOTE
● The ZENEC system is not compatible with vehicles, which are equipped with a hybrid or electro
drive ex factory.
● The ZENEC Z-N426 is equipped with an integrated DAB+ receiver. To make use of this you
will need a suitable DAB antenna (not included in kit) that must be connected to the ZENEC
system.
● If the target vehicle is already equipped with an original DAB antenna, it is still possible to use it
in combination with the ZENEC system.
● The set of this ZENEC device also contains a 2.4GHz Wifi dongle. This dongle can be
connected to the designated USB wire on the device backside.
● Software updates to the ZENEC system are installed with a USB memory device. Therefore
when fitting the system make sure that the USB connection of the ZENEC system will still be
accessible later (installation of USB extension cable or USB hub).
● If you have questions or problems relating to the ZENEC system, please contact the dealer from
whom you purchased it.
REMOVAL WORK AND PREPARATION
NOTE
1. Remove the ignition key and keep it outside the car until the installation is finished.
2. Please wait for ca. 10 minutes until the CAN bus system is completely shut down, before
you start with the deinstallation of the original device.
3. Start with the deinstallation of the original device.
4. Please switch on the ignition only, when all work steps are done and the ZENEC system is
completely mounted.
NOTE
● Make sure that all connectors at the rear of the ZENEC system have sufficient room and are
not bent.
● Connectors without a retaining mechanism must be additionally secured with insulating tape.
72
OVERVIEW INCLUDED ACCESSORIES
No. Article
1
Main device user manual
2 2DIN trim frame
3 2DIN metal device mounting cage
4 ISO-DIN main harness
5 Camera / Reverse Signal / Steering Wheel Control interface
6 4.2 RCA preamp line out
Bluetooth RCA preamp line out
7
8 USB extension cable
9 Parking break wire
10 GPS antenna with cable and Fakra connector
11 Bluetooth microphone with mounting clip
12 Factory radio removal tool
13 2.4GHz Wifi dongle
COMMISSIONING
Make sure that the vehicle is located outside, and that the GPS reception is not adversely affected
by any shadowing (trees, high buildings etc.). Now insert the navigation software SD card supplied
into the microSD card slot of the ZENEC system, and start it in order to establish a sat fix. Make sure
that the vehicle is not moved until the sat fix is established. Now press the NAV button to start the
navigation mode, and choose map view. Once your present location can be seen in the map view the
sat fix has been established. This can take 3 to 5 minutes. You can now use the ZENEC system.
Finally carry out a general functional test and perform the basic and car specific settings (AC, OPS
etc.). Also ensure that no fault warnings appear on the vehicle side.
Qty
1
1
1
1
1
1
1
1
1
1
1
1
1
73