Programming, Testing, And Printing Reports; User Level Programming - Ricoh FAX220 Service Manual

2. PROGRAMMING, TESTING, AND PRINTING REPORTS

2-1. USER LEVEL PROGRAMMING

Function List
No. Function
Quick Dial Programming
01
Speed Dial Programming
02
Telephone List Printing
03
Set Fax Switch
04
05 Send Later
06 Polling Transmission
07 Polling Reception
TCR Printing and On/Off
08
09 Transmission Report On/Off
10 Page Header (TTI) On/Off
11 Enter Page Header (TTI)
12 Enter Your Name (RTI)
13 Enter Your Fax Number (CSI)
14 Clock Adjustment
15 Set PBX
ID Code Programming
16
17 Key Touch Tone On/Off
RDS On/Off
18
19 Set Language
Authorized Reception On/Off
20
21 Reviewing Stored Documents
Forwarding
22
23 Group Dial Programming
24 ECM On/Off
Use to program a telephone number and a label in each Quick Dial
key.
Use to program a telephone number and a label in each Speed Dial
code.
Use to print the telephone list, which contains Quick Dials, Speed
Dials, and Groups.
Use to select the function of Auto Select mode from among AUTO
mode (Auto Tel/Fax switch), TAM mode, and FAX mode (Automatic
Receive).
Use to program the machine to send a document at a later time.
Use to set up a document to be polled from a remote terminal.
Use to program the machine to poll documents from remote terminals.
Use to print a TCR or to set the machine up to print reception only on
the TCR.
Use to switch automatic Transmission Report output on or off.
Use to switch the TTI printout on each transmitted page on or off.
Use to program the TTI.
Use to program the RTI.
Use to program the CSI.
Use to adjust the date and time.
Use to program the machine for the actual PBX type.
Use to program the ID code, which is used for secured polling and the
closed network feature (closed network can only be switched on in
service mode).
Use to switch the key touch tone off or on.
Use to switch RDS on or off.
This function cannot be accessed by the users, unless bit 6 of bit
switch 1 is set to 1 by RDS installation operation or by service later.
Use to change the LCD and report language.
Use to prevent reception from terminals other than those programmed
in the Quick/Speed Dials.
Use to review the documents stored in the memory.
Use to program the machine to forward received messages to a
programmed terminal.
Use to make dialing groups (up to 5 groups can be made).
Use this to switch ECM on or off.
2-1
Brief Explanation