Mounting The Transom Mount Bracket - Raymarine RV-100 RealVision 3D Installation Instructions Manual

Mounting the transom mount bracket

The transducer must be mounted on the transom using the mounting bracket provided. The steps
below describe the initial mounting steps required in order to test your transducers performance.
After testing the transducer you must finish the mounting following the instructions in the
the transducer mounting
1. Fix the transducer mounting template to the selected location, using masking or self-adhesive
tape.
1
2
3
2. Ensure the template is parallel to the waterline.
3. Drill 2 x holes for the adjustment slot screws as indicated on the template.
Note: To help prevent chipping of the mounting surface, use painter's tape to mask the drill area.
Note: Do NOT drill the third mounting hole at this stage.
4. Fill the 2 holes with marine grade sealant.
5. Using a pozi-drive screw driver and the screws provided, secure the transom mount bracket
using the 2 adjustment slots.
Note: The third locking screw is not used until the transducer has been successfully tested.
section.
Transducer mounting template
Waterline
Mounting away from propeller
Finishing
9