Table of Contents
Advertisement
SuperServer E200-8B User's Guide
How to Start the Setup Utility
Normally, the only visible Power-On Self-Test (POST) routine is the memory test.
As the memory is being tested, press the <Delete> key to enter the main menu of
the AMI BIOS setup utility. From the main menu, you can access the other setup
screens. An AMI BIOS identification string is displayed at the left bottom corner of
the screen, below the copyright message.
Warning: Do not upgrade the BIOS unless your system has a BIOS-related issue.
Flashing the wrong BIOS can cause irreparable damage to the system. In no event
shall Supermicro be liable for direct, indirect, special, incidental, or consequential dam-
ages arising from a BIOS update. If you have to update the BIOS, do not shut down
or reset the system while the BIOS is updating. This is to avoid possible boot failure.
5-2
Main Setup
When you first enter the AMI BIOS setup utility, you will enter the Main setup screen.
You can always return to the Main setup screen by selecting the Main tab on the
top of the screen. The Main BIOS Setup screen is shown below.
The following Main menu items will be displayed:
Main
Advanced
System Date
System Time
Compliancy
Supermicro X10SBA
Version
Build Date
Memory Information
Total Memory
GOP Information
Intel(R) GOP Driver
TXE Information
Sec RC Version
TXE FW Version
Aptio Setup Utility - Copyright (C) 2013 American Megatrends, Inc.
Boot
Security
Save & Exit
[Wed
02
/12/2013]
[16:49:50]
UEFI 2.3: PI 1.2
1.00
11/28/2013 18:56:28
2048 MB (LPDDR3)
[N/A]
00.05.00.00
01.01.00.1073
Version 2.16.1242. Copyright (C) 2013 American Megatrends, Inc.
5-2
Set the Date. Use tab to
switch between Data elements.
:
Select Screen
:
Select Item
Enter:
Select
+/- :
Change Opt.
F1 :
General Help
F2 :
Previous Values
F3 :
Optimized Defaults
F4 :
Save & Exit
ESC :
Exit
Advertisement
Table of Contents
