Table of Contents
Advertisement
This chapter covers the steps required to install or replace components in the
chassis. The only tool required is a Phillips screwdriver.
Review the warnings and precautions listed in the manual before setting up or
servicing this chassis. These include information in Chapter 4 and the warning/
precautions in the setup instructions
3-1
Removing Power
Before performing most setup or maintenance tasks, use the following procedure
to ensure that power has been disconnected from the system.
1. Use the operating system to power down the system, following the on-screen
prompts.
2. After the system has completely shut down, remove the AC power cord from
the back of the chassis.
3. Remove the AC power cord from the power strip or wall outlet.
Chapter 3
Chassis Components Setup
Chapter 3: Advanced Chassis Setup
3-1
Advertisement
Table of Contents
