Display Functions - Miele PG 8080i Operating Instructions Manual

Display functions

General information
The following functions can be selected
or set with the display:
– The program
– The delay start time
– The settings
The following appears in the display
while a program is running:
– The program stage
– The estimated time left for the
program to run
– Any relevant fault messages and
information
To save energy, the dishwasher will
switch to Standby mode within a few
minutes if no program is running and
no button is pressed. After several
more minutes it switches off
completely (see "Operating the
dishwasher, Standby").
To turn the dishwasher back on, press
the  button.
Commissioning
Settings menu
The "Settings" menu is used to adapt
the electronic module of the dishwasher
to changing requirements.
You access the "Settings" menu by
pressing a specific combination of
buttons.
See the "Settings menu" chapter for
more information.
In the Settings menu, the normal
functions of the buttons underneath the
display are not active, allowing you to
select and confirm menu options with
these buttons.
The left and right arrows in the display
indicate that additional selections are
available. You can use the arrow
buttons underneath the display, as
appropriate, to select these further
options.
Use the center button underneath the
display to confirm messages or settings
and to switch to the next menu or
submenu.
A check  will appear beside the
option which is currently selected.
19