Optional Equipment; Installing The Isolator Lead; Installing The Water Pressure Sensor - Yamaha F150A Service Manual

6. Install the rigging tube retainer "1", and
then fasten it using the plastic tie "2".
1
2

Optional equipment

Installing the isolator lead

1. Remove the cap "1" from the isolator
coupler.
1
2. Connect the isolator lead coupler "a".
3. Route the isolator lead through the
proper hole in the rigging grommet. See
"Rigging grommet description" (3-9).

Installing the water pressure sensor

See 6Y8 Multifunction Meter set up manual
for details of the components.
1. Install the water pressure sensor "1" to
the water pressure sensor adapter "2",
and then tighten the water pressure sen-
sor "1" to the specified torque.
a
1
Water pressure sensor "1":
18 N·m (1.8 kgf·m, 13.3 ft·lb)
2. Remove the plug "1".
1
3. Install a new gasket "1" and the water
pressure sensor adapter "2", and then
tighten the
adapter "2" to the specified torque.
1
2
Water pressure sensor adapter "2":
23 N·m (2.3 kgf·m, 17.0 ft·lb)
4. Remove the water pressure sensor cou-
pler "a" from the cap "1".
5. Connect the water pressure sensor cou-
pler "a" to the water pressure sensor "2".
3-14
Optional equipment
2
1
water pressure sensor
0
1
2
3
4
5
6
7
8
9
10
A