Removing The System Board; Prerequisites - Dell Aurora R6 Service Manual

Removing the system board

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before working inside your
computer, follow the instructions in
computer. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
NOTE: Your computer's Service Tag is stored in the system board.
You must enter the Service Tag in the BIOS setup program after you
replace the system board.
NOTE: Replacing the system board removes any changes you have
made to the BIOS using the BIOS setup program. You must make the
appropriate changes again after you replace the system board.
NOTE: Before disconnecting the cables from the system board, note
the location of the connectors so that you can reconnect the cables
correctly after you replace the system board.

Prerequisites

1 Remove the
2 Follow the procedure from step 1 to step 4 in
unit".
3 Remove the
4 Remove the
5 Remove the
6 Remove the
7 Remove the
8 Remove the processor.
left-side cover.
memory modules.
solid-state drive.
wireless card.
processor fan and heat-sink assembly
graphics card.
computer. After working inside your
After working inside your
"Removing the power-supply
.
123