Configuring The Mrp-Ring - Hirschmann PowerMICE User Manual

Redundant ring structure – MRP-Ring

2.2 Configuring the MRP-Ring

V Set up the network to meet your requirements.
Note: Before you connect the redundant line, you must complete the
configuration of the MRP-Ring.
You thus avoid loops during the configuration phase.
V Select the Redundancy:MRP-Ring dialog.
V For each switch, you enter the desired ring ports 1 and 2.
The following settings are required for the ring ports (for this you
select the Basics:Port Configuration dialog):
Bit rate
Duplex
Autonegotiation
(Automatic Configuration)
Port
Table 6: Port settings for ring ports
Note: When you use 100 Mbit/s and full-duplex with twisted pair cables,
the autocrossing function is deactivated. You therefore use crossover
cables.
Display in "Operation" field:
Forwarding: this port is switched on and has a link.
Inactive: this port is blocked and has a link.
disabled: this port is switched off
not-connected: this port does not have a link.
Redundancy L3P
Release 3.0 01/07
100 Mbit/s
full
off
on
2.2 Configuring the MRP-Ring
1000 Mbit/s
–
on
on
41