Operation; Scanner Status - Panasonic KV-S1025C SERIES Service Manual

9.3.

Operation

This section describes each operation (or status indication), according to the function item list shown in Sec. 9.2.
9.3.1.

Scanner Status

This function indicates the scanner status, updating it every few seconds.
The status messages and their contents are as follows.
Fig. 9.3.1 Scanner Status
Classified Code
—
U11/ U16/ U23
U18
U30
Fxx
—
—
—
—
—
Status Message
Scanner has no error.
A paper jam or double feed has occurred.
Open the scanner's door, remove the
documents, and close the door.
Place the documents back in the document
feed tray.
Paper remains in the scanner.
Open the scanner's door, remove the
documents, and close the door.
Place the documents back in the document
feed tray.
Scanner Door is open!
Please close the door.
System error occurred!
Please consult with a service representative.
No Paper!
Please set the paper.
The rollers need to be cleaned.
Please clean the rollers.
Please select "Clear Counter" button after
cleaning the rollers.
The Double-feed Prevention Roller
(consumable) is reaching the end of their
usable life. To insure reliable operation,
please replace this roller with Roller
Exchange Kit for your specific scanner.
After replacing the roller, select the "Clear
Counter" button.
The Paper Feed Roller (consumable) is
reaching the end of their usable life.
To insure reliable operation, please replace
this roller with Roller Exchange Kit for your
specific scanner.
After replacing the roller, select the "Clear
Counter" button.
Scanner is not connected!
No error
Paper jam or double feed error
Document remains in the scanner, there is
dust around a sensor, or the sensor
arm does not work properly.
ADF Door is open, or does not close tightly.
Or the door detection mechanism does not
work properly.
This type of error code requires a
Service-person's attention.
No paper error
Warning for cleaning the rollers
Warning for replacing the Double-feed
Prevention Roller
Warning for replacing the Paper Feed
Roller
Scanner is not connected to the PC
properly.
65
Contents