2-13.HARNESS PROCESSING OF THE HINGE ASSEMBLY (TRV MODEL)
[ASSEMBLING THE HARNESS CLAMP]
Attach the harness clamp to the DP-78 harness.
•
Place a longer harness to the left side.
Place the shortest harness (8P) in the right side to the bottom.
•
Place the hooking portion of the harness clamp to
•
the right side.
•
Place the harness clamp in the left of the tie
band himeron that ties the three wires.
•
Insert the DP-78 harness in the internal groove of
the harness clamp.
[INSTALLING THE HARNESS CLAMP]
Hook the two claws of the harness clamp on the hinge bracket.
Then attach it to the shaft of the hinge assembly.
Note:
The harness must not be pinched.
•
•
The sheet of the FP-152 flexible board must not be peeled over.
[HARNESS PROCESSING]
Fix the harness using the harness guide of the hinge assembly.
•
While holding the harness clamp, turn the hinge upside down.
•
While being careful not to twist the harness, insert the
longer harness (8P) into the shallow groove and insert the
other harnesses (6P, 12P) to the deeper groove.
Note:
•
Be sure that the harnesses do not climb over the three ribs of the guide.
•
Be sure that the harnesses are not pinched between the harness clamp and the shaft.
[ATTACHING THE HINGE COVER (M)]
Attach the hinge cover (M) to the hinge assembly.
•
Hold the harness so that the harness must not come out from the groove.
•
Be careful so that the hinge cover (M) must not contact with the switch
of the FP-152 flexible board.
[ATTACHING THE HINGE COVER (C)]
Attach the hinge cover (C) to the hinge cover (M).
•
While holding the hinge cover (M) so as not to be dropped,
turn the hinge cover (C) upside down.
•
Route the harness inside the cutout of the hinge cover (M).
•
Attach the hinge cover (C) straight. (Claw hooks at the four positions.)
•
Make an attempt to move the harness gently at the entrance/exit of the hinge
assembly to make sure that the harness can move.
Note:
•
Be sure that the harness is not pinched by the hinge cover.
•
Be sure that the harness can move at the entrance/exit of the hinge assembly.
(8P)
(6P)
(Left side)
Longer harness (8P)
Two shorter harnesses (6P, 12P)
Hinge cover (M)
2-13
Harness clamp
(12P)
Himeron
DP-78 harness
Hooking
portion
(8P)
(Right side)
Harness clamp
Hinge bracket
Shaft
Straight in the direction
of attachemnt
Hinge cover (M)
Hinge assembly
Hinge cover (C)
(6P)
(12P)