Table of Contents
Advertisement
Self-diagnosis Code
Block
Detailed
Function
Code
Difficult to adjust focus
E
6
1
0
0
(Cannot initialize focus.)
Zoom operations fault
E
6
1
1
0
(Cannot initialize zoom lens.)
Handshake correction function does not
E
6
2
0
0
work well. (With pitch angular velocity
sensor output stopped.)
Handshake correction function does not
E
6
2
0
1
work well. (With yaw angular velocity
sensor output stopped.)
Symptom/State
— 10 —
Correction
Inspect the lens block focus reset sensor (Pin qs of CN551 of VC-
234 board) when focusing is performed when the control dial is
rotated in the focus manual mode and the focus motor drive circuit
(IC551 of VC-234 board) when the focusing is not performed.
Note: Use the remote commander RM-95 only for the model without the
focus dial.
Inspect the lens block zoom reset sensor (Pin qf of CN551 of VC-
234 board) when zooming is performed when the zoom lens is
operated and the zoom motor drive circuit (IC551 of VC-234 board)
when zooming is not performed.
Inspect pitch angular velocity sensor (SE451 of SE-101 board)
peripheral circuits.
Inspect yaw angular velocity sensor (SE452 of SE-101 board)
peripheral circuits.
Hide quick links:
Advertisement
Table of Contents
