Siemens SITRANS P DS III Operating Instructions Manual page 97

Connection between blocks via parameters
The output values of the transducer blocks for pressure and electronics temperature can be
fed to the analog input and totalizer function blocks as input values for further processing. To
do this, the parameter "Channel" must be correctly set in each function block.
Table 7- 1
Transducer block
Pressure
Electronics temperature
Parameters for measured value display
The values of the following parameters from the measurement and function blocks can be
shown on the display. The parameter "Source for display" must be set appropriately.
Table 7- 2
Block
Pressure transducer block
Electronics temperature transducer block Electronics temperature
Analog input function block
Totalizer function block
See also
Measured value display (Page 82)
Cyclical data transfer (Page 165)
Acyclic data transfer (Page 170)
SITRANS P DS III/P410 with PROFIBUS PA
Operating Instructions, 02/2016, A5E00053276-08
Connection between blocks
Output value
(Parameters)
Temperature
Secondary variable 1
Secondary variable 2
Measurement value (pri-
mary variable)
Secondary variable 3
Electronics temperature
Visualization on the display
Operator control functions via PROFIBUS
7.1 Communications structure for PROFIBUS PA
Usable in the analog
input function block
X
X
X
X
X
X
Parameter
Temperature
Secondary variable 1
Secondary variable 2
Measurement value (pri-
mary variable)
Secondary variable 3
Raw pressure value
Output
Totalizer output
Usable in the totalizer
function block
X
X
Can be shown on the display
X
X
X
X
X
X
X
X
97