Initial Power On; Initial Power On Procedure - Omron NYB17-11 User Manual

5 Installation
5-6

Initial Power ON

This section describes how to Power ON the Industrial Box PC for the first time.
Ensure that installation and post-installation checks of the product are
performed by personnel in charge who possess a thorough understand-
ing of the machinery to be installed.
5-6-1

Initial Power ON Procedure

Use the following procedure to power ON the Industrial Box PC for the first time.
1
Ensure the following conditions are present before applying power for the first time:
• The Box PC is securely fastened to the mounting surface.
• The Box PC is connected to ground.
• All connectors are securely fastened.
2
Ensure that the connected monitor(s) is powered ON.
3
Connect a keyboard and/or a mouse.
Additional Information
• If using an OMRON Industrial Monitor this may not be required because it has touch function-
ality.
• Do not connect additional storage devices before the installation of the operating system
completed. Adding storage devices like a USB flash drive, an SD memory card or a PCIe
card might influence the default drive letter sequence.
4
Ensure the power supply is ON.
Precautions for Safe Use
Always check the power supply and power connections before applying power.
Incorrect power connections can damage the product or cause burning.
5
Press the power button and release within 1 second.
Refer to 2-3 Power Button on page 2 - 7 for the power button location.
The Box PC starts and the PWR LED will go ON.
Additional Information
• Do not connect or disconnect the DVI-D cable while power is supplied to the Box PC.
• If a Windows operating system is preinstalled then the Windows configuration will automati-
cally start.
Refer to 5-6-2 Windows Startup First Time on page 5 - 46 for Windows configuration details.
6
Verify the ERR LED is OFF.
5 - 44
WARNING
NY-series Industrial Box PC User's Manual (W553)